The weight for every rep count
The most you should manage for each number of reps, going to the limit, rounded to plates you can load.
| Reps | Share of your max | Weight |
|---|---|---|
| 1 | 100% | 115 kg |
| 2 | 95.5% | 110 kg |
| 3 | 92.2% | 107.5 kg |
| 4 | 89.2% | 102.5 kg |
| 5 | 86.3% | 100 kg |
| 6 | 83.7% | 97.5 kg |
| 7 | 81.1% | 95 kg |
| 8 | 78.9% | 92.5 kg |
| 9 | 76.9% | 90 kg |
| 10 | 75% | 87.5 kg |
Training percentages
Most programs write their weights as a percentage of a max. Here is each one for yours.
| Of your max | Weight |
|---|---|
| 95% | 110 kg |
| 90% | 105 kg |
| 85% | 97.5 kg |
| 80% | 92.5 kg |
| 75% | 87.5 kg |
| 70% | 80 kg |
| 65% | 75 kg |
| 60% | 70 kg |
How it works
A set of five at 100 kg says more than “five reps”. The reps you can do at a weight fall in a steady pattern as the weight climbs towards your max, so one hard set is enough to say roughly where that max is.
The calculator adds the reps you did to the reps you had left, then reads what share of a max a set that long stands for. Five reps to the limit is about 86% of a max, so 100 kg for five puts your max near 116 kg.
Up to seven reps it reads that share from a chart of reps against effort that powerlifting coaches have used for years. From eight to ten it also runs the Epley formula, weight × (1 + reps ÷ 30), and keeps the lower of the two answers, because long sets flatter you.
It stops at ten. Past that, a set says more about your stamina than your strength.
How far to trust it
An estimate is only as good as the set behind it. Three things decide that.
- How long the set was. Five reps or fewer estimates well. Eight to ten is rough.
- How honest the count was. “Two left” has to mean two more reps you would have made, with the same form. How to count it.
- The lift. Squat, bench press and deadlift follow the pattern well. Curls and lateral raises don’t, and a one rep max for them isn’t much use anyway.
Read the number as right to within a few percent, not to the kilo.
Bench press, squat and deadlift
The same sum works for all three. Use a recent set you finished cleanly, done the way you always do the lift: your usual depth on the squat, your usual touch or pause on the bench, a deadlift that locked out.
Long sets of deadlifts often end on grip or a tired back, not on leg strength, so estimate a deadlift from five reps or fewer.
What to do with the number
Set your training weights from it, and you never have to test. That is the whole point of an estimate: it tells you what to load without a day spent finding out. Stop testing your max makes the case.
Then start a touch under it. A program run off a max you could hit any day of the week goes better than one run off your best day ever. Train with a max you could hit on a bad day.
Questions
Is an estimated max the same as a tested one?
No. A tested max is what you lifted on one day. An estimate is what your training says you could lift. For setting training weights the estimate is the more useful of the two, because it moves with every hard set you do.
Which formula is best?
Epley, Brzycki and the rest agree closely up to about five reps and drift apart after that. None is right for everyone, which is why this one gets more cautious as the set gets longer.
Why won’t it take 12 or 15 reps?
A set that long is too far from a single for the sum to mean much. Do a heavier set of five to eight and use that.
Does it work in pounds?
Yes. Switch to lb at the top. The sum is the same, and the weights round to 5 lb in place of 2.5 kg.